Electrical Engineering to Design-Build a 35kV Generator Interconnection Substation

Updated: Aug 2, 2018

Electrical engineering to design and install this custom substation to provide reliable service and maximize uptime for this distributed generation (DG) facility. 


Electrical Engineering Company | Electrical Substation

  • A utility remote terminal unit (RTU) for metering data and control was built into the lineup in a dedicated section.

  • Substation equipped with custom SCADA for monitoring generation, troubleshooting alarms and control.

  • Dedicated SCADA switchgear section pre-wired and tested at factory to facilitate the installation for remote communications.

  • Advanced relay settings were incorporated to mitigate arc flash hazards and reduce incident energy.

  • Remote operator panel for breaker control reduces exposures to increase workplace safety.

  • Dual UPS backup provides redundancy for system control power and facilitates maintenance.